EVE-NG Internet Access: Best Practices and Tips for Successful Simulations

If you are using EVE-NG for your network simulations, you might run into issues with internet access. While EVE-NG is an excellent platform for creating and testing network topologies, it does not always provide a straightforward way to connect to the internet. However, with a little know-how and some best practices, you can set up EVE-NG to access the internet and make the most of your simulations. Here are some tips to help you get started.

  1. Understand the EVE-NG networking model

Before you can set up internet access in EVE-NG, it’s essential to understand the platform’s networking model. EVE-NG uses a virtual network, which means that you’ll need to create virtual routers and switches to connect to the internet. These virtual devices act as intermediaries between your physical network and the virtual network in EVE-NG.

  1. Configure the EVE-NG network settings

To enable internet access in EVE-NG, you’ll need to configure the network settings correctly. You can do this by going to the EVE-NG web interface and selecting the “Settings” option. From there, click on the “Network” tab and select the adapter that you want to use for internet access. Ensure that the adapter is in “Bridge” mode and that the network settings are correct for your physical network.

  1. Set up a virtual router

To connect to the internet, you’ll need to set up a virtual router in EVE-NG. This router will act as a gateway to the internet for your virtual network. You can use a variety of virtual routers in EVE-NG, including Cisco routers and open-source routers like VyOS. Once you’ve set up your virtual router, you’ll need to configure its interfaces to connect to the virtual network and the internet.

  1. Configure NAT

One of the most important steps in enabling internet access in EVE-NG is configuring NAT. Network Address Translation (NAT) allows devices on the virtual network to access the internet using a single IP address. To configure NAT, you’ll need to set up rules on your virtual router that translate internal IP addresses to the IP address of the virtual router’s interface connected to the internet.

  1. Test your internet connection

Once you’ve set up internet access in EVE-NG, it’s essential to test your connection to ensure that everything is working correctly. You can do this by launching a virtual machine in EVE-NG and attempting to connect to a website or another resource on the internet. If you can successfully access the internet, you’re ready to start using EVE-NG for your network simulations.

In conclusion, enabling internet access in EVE-NG can be a bit tricky, but with the right knowledge and best practices, it’s entirely achievable. By following the steps outlined above, you can set up internet access in EVE-NG and take full advantage of this excellent platform for network simulation and testing.